Ford Fiesta ST Forum banner

AccessPort v3 0-to-60 and 1/4 mile times

6875 Views 21 Replies 6 Participants Last post by  COBB
Anyone play with the timed runs on the v3 yet? I'm going to log a few runs today to see what I get with my mild mods. If nothing else, it should be consistent. I have no experience with this yet, and I'm curious if others here have found it useful. So far, I just keep a single big gauge up for boost pressure while driving. The options are awesome, but I can only see using the other detail while parked and troubleshooting or dinking around!
1 - 5 of 22 Posts
The 1/4 mile and 0-60 tests use the vehicle's wheel speed sensors. Therefore large amounts of wheel spin can cause odd readings or failed results. We are on a little holiday break, but I'll forward this thread to our Ford team and see if they have any input.

Ian
I would think they would take this wheel speed sensor signal from the rear wheels so as not to see wheel spin during these tests.

Dave
Brilliant idea but does the rear even have speed sensors?

Sent from my SPH-D710 using Tapatalk
Yes,
There ARE rear wheel speed sensors.
They are located on the back side of the rear hub spindle and read a cog on the back of the hub.

Dave
Anytime! Our software releases occur on the last Tuesday of each month, so it looks like the 28th!

Cheers,
-Braden @ COBB
So what happened to the 31st of December? ;)
Just kidding.

Dave
Anytime! Our software releases occur on the last Tuesday of each month, so it looks like the 28th!

Cheers,
-Braden @ COBB

Once again VAPORWARE.

Going to the track this week and was hoping for something.


Sent with my retro keyboard and mouse.

Dave
Sorry for the delay! The ice in Austin really threw us for a loop. The new updated firmware available now has improved rear wheel speed sensor input.

Ian
I keep forgetting it is not warm everywhere.

Will we be getting some of the new toys you added to the Focus?

Dave
1 - 5 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top