Ford Fiesta ST Forum banner
1 - 1 of 17 Posts

· Registered
908 Posts
I think that's the one I put in but I don't have the number handy.

When you install it, you need torx wrenches I think. It surprised me, I thought it would be a couple spring clips holding it together.

Be careful to make sure the lid goes down flat, mine didn't want to go down at the rear passenger side so I had to remove all the screws to start that one and get it to close.

Make sure you don't drop a screw, there are lots of little nooks and crannies that they could fall in to.

Also be careful you don't move the lid too far because there are wires holding it down.

The degree of difficulty is high for an air filter but with the right tool and a little patience it is doable if you're even a tiny bit handy.
1 - 1 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.