Ford Fiesta ST Forum banner
1 - 4 of 4 Posts

· Registered
12 Posts
Discussion Starter · #1 ·
A short but sweet take on the Levels Performance intercooler. I got a chance to install the intercooler yesterday and everything went real smooth without issues taking about an hour and a half to two hours from start to finish. Mounting was easy because the intercooler has its own bracket that attached to a cross bar making the install a breeze as none of the mounting hardware from the stock unit was needed. The intercooler feels much more robust compared to the stock unit which feels like a light weight aluminum toy with plastic ends and its quite a bit thicker. After everything was buttoned up I took it for a ride and made 4 or 5 back to back hard pulls from 1st to 4th, when I started it was about 69 degrees outside reading on the dash and the charge temps cruising were also 69 with the air Intake temps at 68 reading from the accesstuner. Immediately after the last pull was completed the outside temp read 70 with the charge temps reading 79 and the air intake temps reading 78 dropping at a good rate as I cruised back to the house. Once it gets back to Florida 100 degree temps I will post back and update how its going making a few quick pulls. Overall I am happy with my purchase and look forward to installing the piping when its released this week.
I feel like the car is breathing better and making more power but who knows.

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.