Ford Fiesta ST Forum banner
1 - 3 of 61 Posts

· Registered
Joined
·
423 Posts
I guess you all will have to add me to the list of dummies who can't make sense of the oil life monitor. The obstinate system just won't respond the way the manual says it should. I must have re-read that paragraph six times trying to see where I might have mis-understood what it was explaining, but I came up with the same non-response from the system. I've done this about seven times on my 2011, but this one no worky. In addition, I can no longer run a vehicle report even though I ran one back in October. The system says I have to have over 200 miles on the car, despite having turned 10,000 miles. And yes, SYNC services is set up.

Hi-tech is nice when it works right, but it sure is exasperating when it acts up. Sometimes I want to do as Harvey Keitel did in the 1992 movie "Bad Lieutenant", where, in a drug addled rage, he furiously pumped six rounds into the radio with his service revolver after hearing that he had lost a big bet on a baseball game.
 

· Registered
Joined
·
423 Posts
It might not reset if you have anything plugged into the OBDII port. This was the same problem I had trying to run a VHR right after I bought it and had installed my dual Scanguages. We determined that unplugging the Scanguages, driving it for a bit, in my case, driving home from the dealership (~15 miles) was enough to let me run the report.
You might have hit on it, as I do have an Ultragauge plugged into the OBD port. I'll try it again later.
 

· Registered
Joined
·
423 Posts
It might not reset if you have anything plugged into the OBDII port. This was the same problem I had trying to run a VHR right after I bought it and had installed my dual Scanguages. We determined that unplugging the Scanguages, driving it for a bit, in my case, driving home from the dealership (~15 miles) was enough to let me run the report.
Well I just tried the "no OBD" suggestion and now I CAN run a vehicle health report. But the oil life reset still won't function. Stupid system tells me to press in the clutch to start the engine.

Threats don't work. I tried my .38 and it ignores me. Maybe I do need the .44.
 
1 - 3 of 61 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top