Ford Fiesta ST Forum banner
1 - 11 of 11 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hello, new around here, I am looking for OE ST springs but I would consider buying the struts too if you have the whole unit for sale, must be in reasonable condition. Let me know what you have and prices. Thanks!
 

· Registered
Joined
·
104 Posts
What's your offset



Stock ST wheels are 17x7 et +48 on 205/40r17...That's a sidewall height of 82mm or 3.228" overall overall height 23.456". (17 + 3.228x2)

I'm on Cobb springs which lower that car .8" front & .7" compared to stock. With 17x8 et+38 on 205/40R17...That's over 22mm further out than stock and nearly the same inside clearance as stock...

So your sidewall of 4.035"x2 +15" = 23.071" so as long as your offset is between +35 (seen it run without issue on F1STs before) and +48 you'll fit without a problem.

Your actually running a smaller overall diameter than stock. You'll be fine depending on offset.
 

· Registered
Joined
·
6 Posts
Discussion Starter · #6 ·
I'm going for more of a rally look to my build, plus this far up north I drive through deep snow so anything as low as any aftermarket sollutions would have to be seasonal. This year I plowed snow up to my hood at least once a week to get to the main road.
 

· Registered
Joined
·
6 Posts
Discussion Starter · #10 ·


As you can see I could get all 4 springs for roughly 60$ brand new, possibly cheaper if I went through Steve at Tasca. Thank you for the offer but I don't think I will be needing yours unless you can beat that price.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top